Hello!

Did you know that logged in users can see a lot more content?

TTSD-6454, 129112

Fixed defect

Last updated September 26, 2017 by Tekla User Assistance tekla.documentation@trimble.com

TTSD-6454, 129112

When creating an unfolded single part drawing of a polybeampart of a certain shape that is created as a continuous chain of beams passing through points that the user picks

The segments of the polybeam are straight, but segment intersections can be curved. For example, a beam that follows a zigzag line is a polybeam.

or a bent plate(1) part that is created from contour plates, or beams whose profile is a plate

(1) Bent plates can be conical or cylindrical.

Curved beams, spiral beams, or deformed parts cannot be used for creating a bent plate.

(2) component object that represents an angle that is bent from a plate and that connects parts

, bolts that were attached to another segment of polybeam than the first one or to another bent plate(1) part that represents a flat structure

(1) In some contexts, for example in analysis, the term plate object may be used to refer to plates.

(2) plate that represents a steel structure

(2) Plate is mainly used as a connection piece or as a floor plate.

section than the parent bent plate section were sometimes not unfolded properly. This has now been fixed.

Development area: 
Drawings

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.