Hello!

Did you know that logged in users can see a lot more content?

TTSD-1641

Fixed defect

Last updated October 13, 2017 by Tekla User Assistance tekla.documentation@trimble.com

TTSD-1641

Previously, if you created a bent plate(1) part that is created from contour plates, or beams whose profile is a plate

(1) Bent plates can be conical or cylindrical.

Curved beams, spiral beams, or deformed parts cannot be used for creating a bent plate.

(2) component object that represents an angle that is bent from a plate and that connects parts

by using a plate(1) part that represents a flat structure

(1) In some contexts, for example in analysis, the term plate object may be used to refer to plates.

(2) plate that represents a steel structure

(2) Plate is mainly used as a connection piece or as a floor plate.

with a cut on it, and then used the Undo command to remove the bent plate, the cut in the original plate was not effective anymore. This has now been fixed.

Development area: 
Modeling

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.