Hello!

Did you know that logged in users can see a lot more content?

TTSD-15615

Fixed defect

Last updated October 5, 2018 by Tekla User Assistance tekla.documentation@trimble.com

TTSD-15615

Previously, if XS_ENABLE_REBAR_MARK_LEADER_LINE_BASE_POINT_OPTIMIZATION was set to TRUE, Tekla Structures optimized the base pointpoint in a model that is used to define a starting point in surveying and that is used as an anchor point in coordinate and height transformations

A Tekla Structures project can have several base points but only one of them can be the project base point.

Base points allow the use of another coordinate system needed for interoperability and collaboration. Base points can also be used in drawings, and in reports and templates. Model origin is the default base point in Tekla Structures.

Base points are also called control points.

location after you manually dragged the base point into different location. Therefore, in some cases, the base point would move to a different location than the location you dragged it to.

Development area: 
Drawings

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.