I-Beam Reinforcement: Top flange tab

Use the Top flange tab to define the meshes in the top flange of the I-Beam.

Symmetric
The user can define if the zones will be symmetrical or not.
If the user selects symmetrical = Yes, then the zone 1 = zone 5 and zone 2 = zone 4.
Zone 4 and zone 5 will be grayed out.

Length
The bend meshes are placed inside this zone.
There is no overlapping inside the zones or between the zones.
The meshes are placed directly next to each other, touching always the next mesh.
The meshes at the edge of a zone are cut at the edge.

Mesh
The user can define the mesh for every zone separately.
The name of the mesh will be shown on this tab page.
The rest of the attributes will be shown on the Attributes tab.