Duggans Non-Standard Anti-Sag - Parameters tab

Tekla Structures
Not version-specific
Tekla Structures
Cold Rolled
Duggan Steel
duggans
non-standard anti-sag
parameters tab
Environment
Not environment-specific

Use the Parameters tab in the Duggan Steel Non-Standard Anti-Sag Properties panel to control how the connecting members are defined within Tekla Structures.

Image
tekla-structures-duggans-non-std-anti-sag-parameters-tab.png


OptionDescriptionDefaultOther
GroupThis defines the class that all parts will be included in.The default setting is 99. 
Connection Type
(Tube Struts, Threaded Bar, Tiled Roof Strut)
This specifies the type of connecting member to be used for the anti sag.The default is set to Tube Struts. 
Gauge Line 
(Top, Bottom, Middle)
This defines which standard hole position to attach the strut too. Example, "Top" would be the hole on the standard guage line on the top of the purlin web.The default is set to Top. 
Fit Top Plate
(Yes, No)
This specifies whether to apply a plate at the top of the run of tubular struts (the end of the last strut).The default is set to Yes. 
Fit Bottom Plate
(Yes, No)
This specifies whether to apply a plate at the bottom of the run of tubular struts (the start of the first strut).The default is set to Yes. 

See also

Duggans cold rolled - Important information
Duggans Non-Standard Anti-Sag
Duggans Non-Standard Anti-Sag - Bolts tab
Was this helpful?