こんにちは

ログインすると、より多くのコンテンツを表示できることをご存知ですか?

Metsec Base Plate (1006)


Software version: 2019

最終更新 May 13, 2019 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2019
Environment: 
Not environment-specific

Metsec Base Plate (1006)

The Metsec Base Plate detail will add cleats to the bottom end of a column to provide a base for the connection of the column. When used with Metsec sections the detail will use appropriate trimmer cleats by default. You will be required to pick a primary member followed by a point. The point indicates the position along the member to which the cleats will be placed.

Before and after

Tekla Structures model before adding Metsec Base Plate (1006) Tekla Structures model after adding Metsec Base Plate (1006)

Notes

  • Any modification of the selected parts will cause this joint to be updated
  • Compound members must be parallel
  • Column must be a Metsec C-section
  • The column will be cut back appropriately based on the pick position

Selection order example

  1. C-section/compound C-section
  2. Pick a position along the member where the autoform/cleat should be created

The order to select Tekla Structures model when adding Metsec Base Plate (1006)

See also

Metsec cold rolled - Important information
Metsec Base Plate (1006) - Parts tab
Metsec Base Plate (1006) - Parameters tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
まだ投票はありません