Unable to run numbering or create drawing in shared model.
Not version-specific
Tekla Structures
Environment
Not environment-specific
If we join the shared model in different environment other than the actual environment in which the model was created, then we cannot run numbering or generate detailed drawings because the catalogs (material / profile / reinforcement) will list the libraries from the actual environment in which the model was created and shared.
In such case we need to close the model without 'Writing Out' or saving and re-open it with correct environment.
Before opening the shared model we can check the environment that the model belongs to under shared model list, as shown below.
Image
Further when we try to join the shared model with different environment there will be a warning message displayed.
Image
Below is an example of a conflict situation, when shared model is opened with wrong environment.
Image