Slash character in reinforcing bar position numbers


Software version: Not version-specific

Last updated January 7, 2021 by Tekla Global Support tekla.structures.ghd@trimble.com

Environment: 
Not environment-specific

Slash character in reinforcing bar position numbers

Question:
I have some reinforcing bars which have the position numberidentifier that is assigned to all similar parts, assemblies, cast units, or reinforcement

Position number consists of a prefix, separator, and running number. The prefix is part of the position number, identifying a numbering series. The running number is part of the position number, and is the assigned number in the numbering series, based on the start number. The separator is an optional character, such as a slash, that separates the prefix and the running number.

In Tekla Structures, the position numbers assigned in the numbering are shown in marks and templates, for example.

In the US, the term piece mark or ship mark is used to refer to a position number.

("REBAR_POS" in templates, also known as 'Mark' in the default environmentTekla Structures environment that contains basic example settings that are not related to any standards specific to a country or a region

) starting with a slash, for example, "/101" instead of "101". Renumbering does not remove the slash. What can I do?

Answer:
The slash was created because there is a <space> in your reinforcing barreinforcement that represents a steel bar used to reinforce a concrete structure

The steel bars are usually ribbed and they are used to increase the tensile strength of concrete.

prefix. To remove the slash, go to reinforcing bar properties, delete the <space> and renumber the reinforcing bars.

Tags: 
numbering

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet