Hello!

Did you know that logged in users can see a lot more content?

ASDO centre disc


Software version: Not version-specific

Last updated May 16, 2014 by Trimble Solutions Sweden tekla.support.se@trimble.com

Environment: 
Not environment-specific

ASDO centre disc

Select two points in the direction on how you wish to place the centre disc. It is Important to set the start point on the left and the direction on the right to get the position in depth of the component correct. The yellow handle symbolizes the start point and the purple handle the direction of the component.

Settings for the centre disc

1. Select appropriate size of the centre disc and press load. All values are automatically loaded into dialog.

2. Under the parameters tab different settings can be made for name etc. Recommendation is to keep the default settings.
3. Type is generated from size and selections made.
4. Only angles between 45-90 degrees are allowed. If another angle is written which isn’t within the marginal, either 45 or 90 degrees is chosen automatically.

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet