Hello!

Did you know that logged in users can see a lot more content?

ESSVE L ESSVE list


Software version: Not version-specific

Last updated May 16, 2014 by Trimble Solutions Sweden tekla.support.se@trimble.com

Environment: 
Not environment-specific

ESSVE L ESSVE list

L ESSVE list creates a report on all the ESSVE components in the model.

The angle connector, gerber connector, beam shoe etc. are presented in the report. The purlin anchor, trim fix, rafter anchor and universal connector consists of one right and one left part, which for example generates two plus two parts for purlin anchors if you create all four in the component. The rafter anchor always delivers in pairs and has the same product code for the left and right part, which is clarified in the name. The width is shown for the beam shoe and also the amount nails and bolts for specific parts.
Observe that the weight is only an approximately weight. The report is filtering out only ESSVE assemblies in the model, which has ESSVE written as default in the fabricator name field in the component. This means that an L ESSVE list report can be created from the whole model without choosing any parts. Do not change the parts in the components manually, because this report uses the component settings.

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet