Hello!

Did you know that logged in users can see a lot more content?

ASDO Picking procedure for the tie rod system


Software version: Not version-specific

Last updated May 16, 2014 by Trimble Solutions Sweden tekla.support.se@trimble.com

Environment: 
Not environment-specific

ASDO Picking procedure for the tie rod system

When applying the tie rod system into the model, model up help lines from holesmall hollow open throughout a part or assembly that is usually used for fastening parts with bolts or other such objects

Hole is created in the same way as bolts and hole properties are defined in the bolt properties.

to hole to determine the midpoint of the centre disc and the plate(1) part that represents a flat structure

(1) In some contexts, for example in analysis, the term plate object may be used to refer to plates.

(2) plate that represents a steel structure

(2) Plate is mainly used as a connection piece or as a floor plate.

on the column. Snap to the intersection of the help lines and set direction of the centre disc to the right to get the right position in depth.

Snap the tie rod system to the plate hole attached to the column, and then to the centre disc hole, left to right, to get the position right of the tie rod system. Check that the sizes of the components are the same.

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
Average page rating: 1 (1 vote)
Refresh page after voting to show updated result.