Part end offsets Part end offsets Use the Dx, Dy and Dz settings in the part properties to move the ends of a part, relative to its reference lineline between two reference pointsFor example, if the user picks two points to position a beam, these points form the reference line, and handles appear at the line ends.Reference lines can be used in snapping in a snap switch.. You can enter positive and negative values. Alternatively, you can use the contextual toolbar to modify the part's position. Option Description Dx Changes the length of the part by moving the part end point along the reference line. Dy Moves the part end perpendicular to the reference line. Dz Moves the part end in the z direction of the work plane. Examples Position Example Dx End point: 200 Dx End point: -200 Dy End point: 300 Dy End point: -300 Dz End point: 400 Dz End point: -400 Quick feedback Did you find what you were looking for? * Yes Partly No What is missing? The feedback you give here is not visible to other users. We use your comments to improve our content. Need support? Fill in this form instead. Leave this field empty We use this to prevent automated spam submissions. Content rating: Select ratingGive Part end offsets 1/5Give Part end offsets 2/5Give Part end offsets 3/5Give Part end offsets 4/5Give Part end offsets 5/5Cancel rating Average page rating: 1 (1 vote)Refresh page after voting to show updated result.