When you use
Rebar shape catalog and select a shape, you can set the reference point to the start, middle or end of the reinforcing bar leg. When you create the reinforcement in the model, you can move the reinforcement to a new location by dragging the reference point. This is useful, for example, when the reinforcing bar legs are of certain length and you want to aim the reference point, for example, to the middle of a part edge. You can also move the reference point of circular reinforcement shapes.
-
On the
Concrete tab, click
Rebar and select
Rebar shape catalog.
The
Rebar Shape Catalog dialog box opens.
-
Select a reinforcement shape.
-
Set the reference point to the desired location (start, middle, end) by double-clicking the position in the preview of the shape.
-
If needed, modify the bar properties.
-
Click
Apply or
OK.
-
In the model, place the mouse pointer over a part face or edge.
-
Based on the preview, select the desired placing and hold down the
Alt key and click the left mouse button.
The reference point is displayed.
-
Move the reinforcement to a new location by dragging the reference point.
-
Click the middle mouse button to create the reinforcement.
Note:
For circular reinforcement you can set the reference point to the center line as follows:
-
Place the mouse pointer over a column edge to have the reinforcement oriented correctly.
-
Hold down the
Alt key and click the left mouse button.
-
Drag the reference point and hold down
Shift key to snap to the center of column.
-
Click the middle mouse button to create the reinforcement.