Kingspan Autoform One Sided (20)


Software version: 2020

Last updated September 3, 2020 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2020
Environment: 
Not environment-specific

Kingspan Autoform One Sided (20)

The Kingspan Autoform One Sided connection is used to connect a Multichannel (compound or single) to a main member.
 

Before and after

Tekla Structures model before adding Kingspan Autoform One Sided (20) Tekla Structures model after adding Kingspan Autoform One Sided (20)

Tekla Structures model before adding Kingspan Autoform One Sided (20)Tekla Structures model after adding Kingspan Autoform One Sided (20)

Notes

  • Any modification of the selected parts will cause this joint to be updated.
  • If specific values are entered under the Parameters tab, thus overriding the default settings then non standard parts may be created.
  • If this connection is applied to a compound member (beam to column) the two members selected must collide in order for the connection to work.
  • Length of the secondary member must be perpendicular to the main members length.

 

Selection order example

  1. Main member
  2. Multichannel

The order to select Tekla Structures model when adding Kingspan Autoform One Sided (20)

See also

Kingspan cold rolled - Important information
Kingspan Autoform One Sided (20) - Parts tab
Kingspan Autoform One Sided (20) - Parameters tab
Kingspan Autoform One Sided (20) - Bolts tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
Average page rating: 1 (1 vote)
Refresh page after voting to show updated result.