The Kingspan Non-Continuous Rail system joint is normally used when the specified column face to cladding distance is less than that possible for the standard purlin/rail joint. The joint can handle flush or recessed sheeting lines. A non-standard cleat, (either angle or tee), is bolted to the column, and bolted to the rail along the standard gauge lines.

Before and after

Notes

• Any modification of the selected parts will cause this joint to be updated
• Primary member can be an I section or hot rolled channel
• Secondary member must be perpendicular to the primary member and have the same orientation
• Multichannel can be ‘toes up’ or inverted

Selection order example

Select a Cleat Profile under the Parts tab

1. Primary member
2. Multichannel

See also

Kingspan cold rolled - Important information
Kingspan Non-Continuous Rail (106) - Parameters tab
Kingspan Non-Continuous Rail (106) - Parts tab
Kingspan Non-Continuous Rail (106) - Bolts tab