The Kingspan Autoform Detail joint only works with Kingspan Multichannel sections and is used to create an autoform at the end of a Multichannel.
 

Before and after

Notes

• Any modification of the selected parts will cause this joint to be updated.
• If specific values are entered under the Parameters tab, thus overriding the default settings then non standard parts may be created.

Selection order example

1. Multichannel
2. Pick a position along the multichannel where the autoform should be created

See also

Kingspan cold rolled - Important information
Kingspan Autoform Detail (3) - Parameters tab
Kingspan Autoform Detail (3) - Bolts tab