Did you know that logged in users can see a lot more content?

2019i Table of Contents


Last updated September 10, 2019 by Tekla User Assistance tekla.documentation@trimble.com

Software version: 



Category : Numbering

Use this advanced option to define whether the location of the crossing bars (e.g. above or below the main bars) is ignored in the numberingprocess of assigning position numbers to parts, cast units, assemblies, or reinforcement

In Tekla Structures, the position numbers assigned in the numbering are shown in marks and templates, for example.

of reinforcement meshes.

The default value is FALSE.

If XS_IGNORE_CROSSBAR_LOCATION_IN_REBAR_MESH_NUMBERING is set to FALSE , the location of the crossing bars affects numbering, and the otherwise identical meshes receive different numbers if the crossing bars are on the different sides of the main bars.

If XS_IGNORE_CROSSBAR_LOCATION_IN_REBAR_MESH_NUMBERING is set to TRUE , crossing bars can be on either side of the main bars, and the otherwise identical meshes still receive the same number.

This advanced option is model specific and the setting is saved in the options databasedatabase file that contains the settings of model-specific general settings and advanced options

There are two options databases, the model options database (options_model.db) and the drawing options database (options_drawings.db).



We do not recommend that you change this setting during a project. If you do so, you must carry out full numbering ( File > Diagnose & repair > Diagnose and repair numbering: all ).

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet