XS_CONTOUR_PLATE_POINT_ON​_SAME_LINE_LIMIT_FOR​_​CLOSE_​POINTS

Tekla Structures
2019i
Tekla Structures

XS_CONTOUR_PLATE_POINT_ON​_SAME_LINE_LIMIT_FOR​_​CLOSE_​POINTS

Category

Modeling Properties

Cleans away system component provided contour plate profile points in cases where points are on an almost straight line if the provided (middle) points deviate from the line at most as much as the value of this advanced option. The point is then so close to the line between the previous and next point that it is redundant and can be removed. This advanced option is used if section point distances between two consecutive points are smaller than 10.0 mm. The default value for this advanced option is 0.1 mm.

This advanced option is model specific and the setting is saved in the options database.

Was this helpful?
Previous
Next