Number a series of parts

Last updated September 10, 2019 by Tekla User Assistance

Software version: 

Number a series of parts

Number a series of parts

Use the Number series of selected objects command to only number parts that have a certain prefix and start numberfirst number of a numbering series

. This enables you to limit the numberingprocess of assigning position numbers to parts, cast units, assemblies, or reinforcement

In Tekla Structures, the position numbers assigned in the numbering are shown in marks and templates, for example.

to certain series of objects only, which can be useful in large models.

Before you start, we recommend that you plan the numbering seriesset of identifiers defined by the user, based on which Tekla Structures compares parts, assemblies, cast units, or reinforcement with each other during the numbering and gives position numbers

Numbering series is defined by a prefix and a start number.

The user can, for example, allocate separate numbering series to different phases or part types.

carefully, and split the model into smaller numbering series, for example by area or phase.

  1. Select the parts that have the desired prefix and start number.

    Only parts that have the same prefix and start number as the selected part will be numbered.

  2. On the Drawings & reports tab, click Perform numbering > Number series of selected objects.

    Tekla Structures numbers all parts in the specified numbering series.

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet