To change the bolt mark Size element content, go to .
Note: General arrangement drawings have separate advanced options.
Any changes made to the advanced options listed in the table below will take place only in the new drawings you create, and if you modify the affected bolt marks.
You can use any combination of text and the following options as the value for the above advanced options. Enclose each option in % characters. To use special characters enter a backslash (\) followed by an ASCII number. You can use the options in any order, and make calculations.
BOLT_NUMBER
DIAMETER
LENGTH
HOLE.DIAMETER
LONG_HOLE_X
LONG_HOLE_Y
LONGHOLE_MIN (the shorter of the slotted hole dimensions)
LONGHOLE_MAX (the longer of the slotted hole dimensions)
BOLT_STANDARD
BOLT_MATERIAL
BOLT_ASSEMBLY_TYPE
BOLT_COUNTERSUNK
BOLT_SHORT_NAME
BOLT_FULL_NAME
Example
Example of using the advanced options:
XS_LONGHOLE_MARK_STRING_FOR_SIZE=D%HOLE.DIAMETER%(%HOLE.DIAMETER+LONG_HOLE_X%x%HOLE.DIAMETER+LONG_HOLE_Y%)
XS_SITE_HOLE_MARK_STRING_FOR_SIZE=D%HOLE.DIAMETER%
Please note that for calculations the operator (+, -, *, /) must not be outside the "%" marks:
Correct: %OPTION1*OPTION2%
Incorrect: %OPTION1%*%OPTION2%
For example, if OPTION1 = 5.0 and OPTION2 = 3.0, the results would be "15" and "5*3"