Use the Part 1 , Part 2 , Part 3 or Part 4 tab to create one additional part or cut to the concrete part.
Profile
Select the profile to be added to the concrete part or used for the cut.
Select how the added part is connected to the main part.
Option |
Example |
---|
|
No part created.
|
|
Part is created.
|
|
Part is created and added to the main part.
|
|
Part is created and the main part is cut.
|
|
Main part is cut.
|
|
Part is created and cast unit is created.
|
|
Part is created and welded to the main part.
|
|
Part is created and welded to the main part, and the main part is cut.
|
|
Part is created and added as sub-assembly.
|
|
Part is created and added as sub-assembly, and the main part is cut.
|
Offset
Define the offset of the added part from the main part. You can set the offset also for openings.
By default, the added parts or cuts are created between the end points of the concrete part.
Coordinate system
On the Part 1 tab, select Use global xy-plane to place the corbels on the global XY plane or Use local to place the corbels on the local XY plane of the part.
Note that setting the coordinate system on the Part 1 tab also affects the corbels that are created on the Part 2 - 4 tabs.
Create diamond corbel around column
Select whether a diamond corbel is created around the column.
If you create the corbel, you cannot enter any values on the Part 2 , Part 3 or Part 4 tabs.
Chamfers
You can chamfer the added parts. You can define the chamfers either as angles or as dimensions.
Positioning of the parts
Option |
Description |
---|
|
Select the side where the added parts or cuts are created.
|
|
Select the alignment of the added parts or cuts.
|
|
You can swap the end points of the added parts or cuts.
|
|
Select whether the existing cuts should be taken into account when the added parts are created.
|
Part 2 / Part 3 / Part 4 tab
You can add or cut more than one part at the same time. To do this, use the tabs Part 2 , Part 3 and Part 4.