Use the Picture tab to control the dimensions of the secondary round tube fitting and the gap between the round tubes.
Part dimensions
|
Description
|
Default
|
---|
1
|
Pop mark offset.
You can define the offset if you have set the Position of pop mark option to At minimum angle , At maximum angle , or Both.
|
100 mm
|
2
|
Pop mark diameter.
You can define the diameter if you have set the Position of pop mark option to At minimum angle , At maximum angle , or Both.
|
10 mm
|
3
|
Gap between the main and the secondary round tube.
|
|
Secondary part fitting
Option
|
Description
|
---|
|
Default
The secondary round tube is cut with the main round tube.
AutoDefaults can change this option.
|
|
The secondary round tube is cut with the main round tube.
|
|
The secondary round tube is fitted to the center line of the main round tube and then cut.
|
Position of pop mark
Select the position of the pop mark.