|
Saddle
Creates a standard saddle on the secondary part, fitting it to the main part.
Weld preparations are created to the secondary part during NC processing.
|
|
Set-on Saddle+Hole
Creates a standard saddle on the secondary part, fitting it to the main part. Creates also a hole in the main part which matches the inner diameter of the secondary part.
Weld preparations are created to the secondary part during NC processing.
|
|
Set-in Saddle+ Hole
Creates a saddle on the secondary part, fitting it to the inner surface of the main part. Creates also a hole in the main part which matches the outer diameter of the secondary part.
Weld preparations are created to the hole on the main part during NC processing.
|
|
Set-on Hole Only
Creates a hole in the main part which matches the inner diameter of the secondary tube. The secondary part is not modified in any way.
No weld preparations are created during NC processing.
|
|
Set-in Hole Only
Creates a hole in the main part which matches the outer diameter of the secondary part. The secondary part is not modified in any way.
Weld preparations are created to the hole on the main part during NC processing.
|
|
Edge Saddle
Creates a partial saddle on the secondary part to a main part which only partially overlaps with the secondary part.
Weld preparations are created to the secondary part during NC processing.
|
|
Offshore Saddle
Creates back bevel during the tube NC file creation. No actual back bevel is created in the model.
|