Hello!

Did you know that logged in users can see a lot more content?

BW Diagonal Ties (55)


Software version: 2019i

Last updated November 8, 2019 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2019i
Environment: 
Not environment-specific

BW Diagonal Ties (55)

The BW Industries' Diagonal Ties macrosaved series of actions that includes instructions for a program

Macros are located in the applications and components catalog. They are recorded or created manually and stored as .cs file in a folder defined with the advanced option XS_MACRO_DIRECTORY.

Macros can, for example, be used for creating drawings or reports.

Macros are sometimes used to run an application.

allows the placing of one or two diagonal tie wire or angle between any two or three selected bolts.

Before and after

Tekla Structures model before adding BW Industries Diagonal Ties (55) Tekla Structures model after adding BW Industries Diagonal Ties (55)

Notes

  • It is important to realise that any modification of the parts to which this macro applies is likely to cause incorrect results in the model. This is because the items created by a macro are not redefined when changes are made to the previously selected members. If the diagonal tie bracket is placed using the Below option then suitable modifications will be made to the lengths of the side rail support or anti-sag bar. These will not revert back to their original state if the diagonal tie is subsequently deleted and so they should be reapplied again after the removal of a diagonal tie. 
  • To reduce unnecessary parts in the models/clarity the end brackets are not modelled.
  • When three bolts are selected, the middle bolt must be to the lower cleat on the restraint. A pair of diagonal ties will be positioned between the bolts, fitted under the end cleat and the strut will be shortened accordingly. If two bolts are selected then the tie will be connected on top of the end cleat. The holes will normally be:
  1. The purlin / rail cleat bolt nearest the rafter / stanchion (or the inside bolt in the anti-sag / side rail support cleat) for the top of the tie
  2. Either bolt in the anti-sag / side rail support cleat for the bottom of the tie
  • The BW diagonal tie is designed to cater for angles between 27.5 degrees and 47.5 degrees. 

Selection order example

When selecting a bolt ensure both Select bolts  and Select objects in components  are turned on.
When selecting a point ensure Select all  is turned on.

  1. Bolt
  2. Bolt
  3. Bolt (if required)
  4. Click middle mouse button

The order to select Tekla Structures model when adding BW Industries Diagonal Ties (55)

See also

BW cold rolled - Important information
BW Diagonal Ties (55) - Parts tab
BW Diagonal Ties (55) - Parameters tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet