Hello!

Did you know that logged in users can see a lot more content?

BW Non-Standard Horizontal Cladding Support (34)


Software version: 2019i

Last updated November 8, 2019 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2019i
Environment: 
Not environment-specific

BW Non-Standard Horizontal Cladding Support (34)

The BW Industries' Non-Standard Horizontal Cladding Support macrosaved series of actions that includes instructions for a program

Macros are located in the applications and components catalog. They are recorded or created manually and stored as .cs file in a folder defined with the advanced option XS_MACRO_DIRECTORY.

Macros can, for example, be used for creating drawings or reports.

Macros are sometimes used to run an application.

can be used to define individual PJR sections between selected side rails. The macro can also be used between the top rail in a bay and an eaves beam.

Before and after

Tekla Structures model before adding BW Industries Non-Standard Horizontal Cladding Support (34) Tekla Structures model after adding BW Industries Non-Standard Horizontal Cladding Support (34)

Notes

  • It is important to realise that any modification of the parts to which this macro applies is likely to cause incorrect results in the model. This is because the items created by a macro are not redefined when changes are made to the previously selected members. If it is necessary to change any of the members upon which the macro is dependent then first delete all the parts created by the macro, make the required changes and finally re-apply the macro.
  • Most of the data required for this macro is fixed by BW and stored in a series of data files supplied with Tekla Structures. Where standard data is not applicable, then certain items can be modified through the Parameters tab of the properties panel, but it is also possible to tailor the data files to individual requirements. This would require assistance from Tekla Structures support.
  • Only one eaves beam may be selected for inclusion.
  • All rails in the bay must share the same sheeting face.
  • All rail lengths must be parallel.
  • Eaves beam must be parallel to rails and above the last rail. 

Selection order example

  1. Rail
  2. Rail
  3. Pick a point or holesmall hollow open throughout a part or assembly that is usually used for fastening parts with bolts or other such objects

    Hole is created in the same way as bolts and hole properties are defined in the bolt properties.

    (the point must be a Tekla point object, rather than a snap pointpoint to which Tekla Structures snaps

    )

The order to select Tekla Structures model when adding BW Industries Non-Standard Horizontal Cladding Support (34)

See also

BW cold rolled - Important information
BW Non-Standard Horizontal Cladding Support (34) - Parts tab
BW Non-Standard Horizontal Cladding Support (34) - Parameters tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet