Hello!

Did you know that logged in users can see a lot more content?

BW Non-Continuous Rail (134)


Software version: 2019i

Last updated November 8, 2019 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2019i
Environment: 
Not environment-specific

BW Non-Continuous Rail (134)

The BW Industries' Non-Continuous Rail system joint is normally used when the specified column face to cladding distance is less than that possible for the standard purlin/rail joint. The joint can handle flush or recessed sheeting lines. A non-standard cleat, (either angle or tee), is welded to the column, and bolted to the rail using holes along the standard gauge lines.

Before and after

Tekla Structures model before adding BW Industries Non-Continuous Rail (134) connection Tekla Structures model after adding BW Industries Non-Continuous Rail (134) connection

Notes

  • Any modification of the selected parts will cause this joint to be updated.
  • If specific values are entered under the Bolts tab, thus overriding the default bolt positions then non standard parts may be created.

Selection order example

  1. Column
  2. Rail

The order to select Tekla Structures model when adding BW Industries Non-Continuous Rail (134)

See also

BW cold rolled - Important information
BW Non-Continuous Rail (134) - Parts tab
BW Non-Continuous Rail (134) - Parameters tab
BW Non-Continuous Rail (134) - Bolts tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet