Metsec Non-Continuous Rail (106)
The Metsec Non-Continuous Rail system joint is normally used when the specified column face to cladding distance is less than that possible for the standard purlin/rail joint. The joint can handle flush or recessed sheeting lines. A non-standard cleat, (either angle or tee), is welded to the column, and bolted to the rail using holes along the standard gauge lines.
Before and after
Notes
- Any modification of the selected parts will cause this joint to be updated.
- If specific values are entered under the bolts tab, thus overriding the default bolt positions then non standard parts may be created.
- Primary member can be an I section or channel
- Secondary member must be perpendicular to the primary member and have the same orientation
Selection order example
- Column
- Rail
See also
Metsec cold rolled - Important information
Metsec Non-Continuous Rail (106) - Parts tab
Metsec Non-Continuous Rail (106) - Parameters tab
Metsec Non-Continuous Rail (106) - Bolts tab