Hello!

Did you know that logged in users can see a lot more content?

Update drawings when the model changes

Last updated March 12, 2019 by Tekla User Assistance tekla.documentation@trimble.com

Software version: 
2019

Update drawings when the model changes

Update drawings when the model changes

Saved drawings need updating because of model changes. Cast-unit, assembly, single part and multidrawings use position numbers as identifiers. Many changes affect numberingprocess of assigning position numbers to parts, cast units, assemblies, or reinforcement

In Tekla Structures, the position numbers assigned in the numbering are shown in marks and templates, for example.

, so many times renumbering is needed. Before updating drawings you need to ensure that the numbering is correct.

The drawings needing updates are indicated by flags in Document manager. Renumbering model objects after creating drawings may also generate flags.

Note:
  • General arrangement drawings do not require model numbering to be updated. If you use part positionposition number that is assigned to a part

    numbers in part marks, you must number the model to get updated marks, because old and not up-to-date part marks have question marks in them. If you do not use numbering, you can modify general arrangement drawings without numbering. Then, for example, profile changes are highlighted with change symbols.
  • When you update multidrawings, also the linked drawings are updated.

Do the following after changing the model:

  1. Check the numbering settings by going to the Drawings & reports tab and clicking Numbering settings > Numbering settings .
  2. Select Compare to old for both the new and modified parts.
  3. Number all model objects that have same numbering seriesset of identifiers defined by the user, based on which Tekla Structures compares parts, assemblies, cast units, or reinforcement with each other during the numbering and gives position numbers

    Numbering series is defined by a prefix and a start number.

    The user can, for example, allocate separate numbering series to different phases or part types.

    settings on the Drawings & reports tab by clicking Perform numbering > Number series of selected objects , or number only new or modified model objects by clicking Perform numbering > Number modified objects .
  4. Check the Document manager for status flags.
  5. To find the parts that have been affected, select each drawing marked with theflag in the Document manager and click the Select objects button.

    Tekla Structures highlights the affected parts in the model.

    Do the following:

    1. Check the numbering history log for renumbered parts by going to the File menu and clicking Logs > Numbering history log .

      Part or Assembly at the beginning of a line in the numbering history log indicates that Tekla Structures has renumbered parts or assemblies, as in the following example:

    2. To find the renumbered parts in the model, select the relevant entries from the numbering history log. Tekla Structures highlights the corresponding parts in the model.
  6. Select the affected drawings from Document manager and click Update.
  7. If you have new parts in the model, create drawings for them.

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet