Align selected drawing objects

Tekla Structures
2019
Tekla Structures

Align selected drawing objects

You can align objects (texts, marks, views and graphical objects) to the bottom, to the middle, to the left, to the center, to the right, and to the top. You can also position objects horizontally or vertically at equal distances from each other.

  1. Open a drawing.
  2. Select the objects that you want to align.

    You can select one or several objects using appropriate selection switches or filters and area selection, for example. If you want to align marks and notes only, you can use Drawing content manager for first selecting the building objects and then the related marks or notes.

    For more information about Drawing content manager , see Drawing content manager.

  3. Do any of the following:

    To Do this

    Align selected texts, marks, views and graphical objects

    1. Select the aligning command from the toolbar:

      Clickto align objects to the bottom.

      Clickto align objects to the top.

      Clickto align objects to the left.

      Clickto align objects to the right.

      Clickto align objects to the center.

      Clickto align objects to the middle.

      Clickto position objects to the vertical center at equal distances.

      Clickto position objects to the horizontal center at equal distances.

    2. Pick a location for the alignment.

      If you have mixed objects selected, you will be asked to select which objects you want to align.

    3. If you selected one of the two commands that position objects to center at equal distances, type the distance in the displayed dialog box.

    Tip:

    To create a row of objects, align them first to the top and then position them horizontally at equal distances from each other. You do not need to reselect the objects between the two commands.

    Align selected marks and notes automatically

    • Click Align marks > Auto-align marks on the Annotations tab.

    This aligns the selected marks and notes by stacking the marks or notes and placing them evenly.

    This command applies to all marks and associative notes, except weld marks.

    Align selected marks and notes around a point

    • Click Align marks > Align to a point on the Annotations tab and pick a point.

    This command tries to avoid crossing leader lines when placing the marks.

    This command applies to all marks and associative notes, except weld marks.

Example

Below is an example where marks have been aligned to left.

Was this helpful?
Previous
Next