1 |
Width of the top chord in section 1 (in front view). |
2 |
Width of the inclined column cut-out. |
3 |
Height of the column cut-out. |
4 |
Offset of the plate that is under the block. The offset is relative to the foundation block.
|
5 |
Thickness of the plate under the block. |
6 |
Width of the bottom chord in section 1 (in front view). Width of section 2 and section 3 (in front view).
|
7 |
Distance between the foundation block and the sides of the column. |
8 |
Select how the sections in the foundation block are connected. |
9 |
Select the reference point of the foundation block. Additionally, you can set the vertical offset:
|
|
Component insertion point is at the bottom side of the foundation block. Note that the red part (additional plate under the block) is not taken into account.
|
|
Component insertion point is at the bottom side of the cut-out of the column.
|
|
Component insertion point is at the bottom side of the column.
|
|
Component insertion point is at the top of the foundation block. |
10 |
Width of the top chord in section 1 (in side view). |
11 |
Distance from the bottom of the column to the foundation block. |
12 |
Width of the bottom chord in section 1 (in side view). Width of section 2 and section 3 (in side view).
|
13 |
Select the cast unit type. |