CRANK_xxx
CRANK_xxx
Use the following template attributes to show rebar set bar crank information defined by using a rebar set splitterrebar set modifier that can be used to split the reinforcing bars in a rebar set and to create reinforcement splices
.
(1) = Location of the splitterrebar set modifier that can be used to split the reinforcing bars in a rebar set and to create reinforcement splices
Template attribute | Description |
---|---|
CRANK_SIDE_START CRANK_SIDE_END |
Shows to which side of the splitter the crank is created at the start or end of the bar: Left or Right. |
CRANK_ROTATE_START CRANK_ROTATE_END |
Shows to which angle the crank is rotated at the start or end of the bar. |
CRANK_STRLEN_START CRANK_STRLEN_END |
Shows the length of the straight segment of the crank at the start or end of the bar. This is (2) in the image above. |
CRANK_LENTYPE_START CRANK_LENTYPE_END |
Shows the type of the cranked length at the start or end of the bar: Diagonal ratio , Diagonal distance , Horizontal ratio , Horizontal distance. |
CRANK_RATIO_START CRANK_RATIO_END |
Shows the multiplier of the bar diameter that is used to define the cranked length at the start or end of the bar. |
CRANK_DIST_START CRANK_DIST_END |
Shows the length of the cranked segment at the start or end of the bar. If the cranked length type is Horizontal distance , this is (3) in the image above. If the cranked length type is Diagonal distance , this is (4) in the image above. |
CRANK_OFFSET_START CRANK_OFFSET_END |
Shows the offset distance of the straight segment of the crank at the start or end of the bar. This is (5) in the image above. |