Hello!

Did you know that logged in users can see a lot more content?

2018i Table of Contents

XS_​BOLT_​DUPLICATE_​TOLERANCE

Last updated September 10, 2018 by Tekla User Assistance tekla.documentation@trimble.com

Software version: 
2018i

XS_​BOLT_​DUPLICATE_​TOLERANCE

XS_​BOLT_​DUPLICATE_​TOLERANCE

Category : Numbering

When XS_​BOLT_​DUPLICATE_​IGNORE is set to TRUE , use XS_BOLT_DUPLICATE_TOLERANCE to set the location tolerance that defines which bolt holes are considered duplicates and will therefore be ignored in part numberingprocess of assigning position numbers to parts, cast units, assemblies, or reinforcement

In Tekla Structures, the position numbers assigned in the numbering are shown in marks and templates, for example.

.

The default value for the tolerance is 3 mm.

Note:

It is not recommended to change this advanced option during a project, but if you do so, you must carry out full numbering.

This advanced option is model specific and the setting is saved in the options databasedatabase file that contains the settings of model-specific general settings and advanced options

There are two options databases, the model options database (options_model.db) and the drawing options database (options_drawings.db).

.

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet