Hello!

Did you know that logged in users can see a lot more content?

Thomas Panels Non-Continuous Rail (106)


Software version: 2018i

Last updated April 3, 2019 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2018i
Environment: 
Not environment-specific

Thomas Panels Non-Continuous Rail (106)

The Thomas Panels and Profiles Non-Continuous Rail system joint is normally used when the specified column face to cladding distance is less than that possible for the standard purlin/rail joint. The joint can handle flush or recessed sheeting lines. A non-standard cleat, is bolted to the column, and bolted to the rail along the standard gauge lines.

Before and after

Tekla Structures model before adding Thomas Panels Non-Continuous Rail (106) Tekla Structures model after adding Thomas Panels Non-Continuous Rail (106)

Notes

  • Any modification of the selected parts will cause this joint to be updated
  • Primary member can be an I section or hot rolled channel
  • Secondary member must be perpendicular to the primary member and have the same orientation
  • The rail can be ‘toes up’ or inverted

Selection order example

  1. Primary member
  2. Rail

The order to select Tekla Structures model when adding Thomas Panels Non-Continuous Rail (106)

See also

Thomas Panels cold rolled - Important information
Thomas Panels Non-Continuous Rail (106) - Parts tab
Thomas Panels Non-Continuous Rail (106) - Parameters tab
Thomas Panels Non-Continuous Rail (106) - Bolts tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet