1. Home
  2. Tekla Structures
  3. Create drawings
  4. Edit drawings
  5. Create and modify drawing views
  6. Create a detail view

Create a detail view

Tekla Structures
2018i
Tekla Structures
виды узлов
создать вид узла
Вид узла

Create a detail view

You can create a detail view from a selected area in an existing drawing view in another view. The scale of the detail view is by default the same as that of the main view, but in some environments the detail view is scaled up. The direction of the detail view is the same as that of the original view. Before creating the detail view label and detail mark define a start number or letter in the drawing properties.

  1. Open a drawing.
  2. Set the detail mark properties first: On the Drawing tab, click Properties > Detail mark .
  3. Enter a name for the detail, and modify the detail view label, detail boundary and detail mark properties in the Detail Properties dialog box.

    The shape of the detail boundary you select affects the way you select the area for your detail.

  4. Click OK or Apply.
  5. Next, set the view properties: Hold down Shift and, on the Views tab, click Detail view.
  6. Modify the view properties as required.
  7. Click OK or Apply.
  8. Depending on the selected detail boundary shape, do one of the following:

    • If the shape is Circle , pick the center point of the circle and then pick a point on the circle.

    • If the shape is Rectangle , pick corner points for the rectangle.

  9. Pick a position for the detail mark.
  10. Pick a position for the detail view.

Tekla Structures creates the detail view using the current properties in the View Properties dialog box and Detail Properties dialog box. The detail view takes the view depth from the original view even if you try to change it. You can change the properties after creating the view.

(1) Detail boundary is set to Circle. You can increase or decrease the detail symbol size by dragging the handle on the detail boundary.

(2) Detail mark

(3) Detail view

(4) Detail view label

Define a start number or letter for detail view label and mark

  1. Double-click an open drawing.
  2. Click the check box toggle selection button at the bottom of the dialog box, and select only the check box next to the Detail view button.
  3. Click Detail view.
  4. Enter the start number or letter.
  5. Click Modify.
Was this helpful?
Previous
Next