Hello!

Did you know that logged in users can see a lot more content?

2017i Table of Contents

XS_​CENTER_​LINE_​TYPE

Last updated September 6, 2017 by Tekla User Assistance tekla.documentation@trimble.com

Software version: 
2017i

XS_​CENTER_​LINE_​TYPE

XS_​CENTER_​LINE_​TYPE

Category : Drawing Properties

Drawing Properties

Use this advanced option to change the line type of the part center lines in drawings. Enter an integer value from 1 to 7. To see the center line type change, close the drawing and open it again.

Value

Description

1

Solid line

2 - 7

Dotted lines.

The default value is 4 (dash-and-dot line).

If you enter a value that is lower than 1 or higher than 7 , Tekla Structures uses the default value 4.

Tip:

To see what the line types look like, see the Hidden lines > Type options on the Appearance tab in Part Properties.

This advanced option is model specific and the setting is saved in the options databasedatabase file that contains the settings of model-specific general settings and advanced options

There are two options databases, the model options database (options_model.db) and the drawing options database (options_drawings.db).

.

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
Average page rating: 5 (1 vote)
Refresh page after voting to show updated result.