Hello!

Did you know that logged in users can see a lot more content?

Numbering history log file

Last updated September 20, 2017 by Tekla User Assistance tekla.documentation@trimble.com

Software version: 
2017i

Numbering history log file

Numbering history log file

The numberinghistory.txt log file contains full details of each numberingprocess of assigning position numbers to parts, cast units, assemblies, or reinforcement

In Tekla Structures, the position numbers assigned in the numbering are shown in marks and templates, for example.

session carried out on the model. Each numbering session is in a different block of the file.

Note:

If you remove or delete the numberinghistory.txt log file, Tekla Structures generates a new file with the same name next time when you run numbering. The new file does not contain a history of previous numbering sessions.

Example

Below is an example of the contents of a numberinghistory.txt log file.

1

User name, date and time of the numbering.

2

Numbering method.

  • Modified numbering is displayed when you run the Number modified objects command.

  • Modified numbering for selected series is displayed when you run the Number series of selected objects command.

  • Diagnose & Repair Numbering: All is displayed when you run the Diagnose & repair numbering: All command.

  • Diagnose & Repair Numbering: Series of selected objects is displayed when you run the Diagnose & repair numbering: Series of selected objects command.

  • Renumber all is displayed when you select the Renumber all option in the Numbering Setup dialog box.

3

Some Compare options set in the Numbering Setup dialog box are displayed in the numberinghistory.txt log file only if they are set differently than the default value:

  • Compare modified to old parts

  • Compare new to old part

  • No holes comparing

  • No part name comparing

  • Beam orientation

  • Column orientation

Some Compare options are not displayed at all:

  • Reinforcing bars

  • Embedded objects

  • Surface treatment

4

Numbering options.

  • Use old numbers is displayed only when you have selected the Re-use old numbers option in the Numbering Setup dialog box.

  • Check for standard parts is displayed only when you have selected the Check for standard parts option in the Numbering Setup dialog box.

5

Tolerances are set in the Numbering Setup dialog box.

6

Changes in the position numbers and in the numbering series during one numbering session.

 

In addition:

If a numbering series overlaps another, the errors are written to the log file.

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet