Kingspan Horizontal Cladding Sleeve (120)


Software version: 2017i

Last updated August 27, 2019 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2017i
Environment: 
Not environment-specific

Kingspan Horizontal Cladding Sleeve (120)

The Kingspan Horizontal Cladding Sleeve connection is used to create a cleat connection between one or two Multichannel rails to a column/stanchion. It can be used for sleeved joints, butt joints, in the middle of double span purlins/rails and at gable ends. It should not be used for connections to hip rafters for which a separate joint is available.

For simplicity, this help text, and the joint dialogue, will refer only to purlins and rafters, but unless explicitly stated otherwise, these terms should be taken to mean purlins/rails and rafters/stanchions.

Before and after

Tekla Structures model before adding Kingspan Horizontal Cladding Sleeve (120) Tekla Structures model after adding Kingspan Horizontal Cladding Sleeve (120)

Notes

  • Any modification of the selected parts will cause this joint to be updated.
  • The joint will work with different rail depths with a common sheeting line distance, contact Kingspan for clarification on the standard sheeting line distances available with this system.

Kingspan Horizontal Cladding Sleeve (120) will work with different rail depths

  • Most of the data required for this joint is fixed and is stored in a series of data files supplied with Tekla Structures. The joint cannot handle purlins which are not explicitly included in these files, Tekla Structures will give an error message and leave a red joint symbol. Please contact Tekla Structures support for assistance if that occurs.
  • Purlin Positioning
    1. To achieve the correct bolt positions in purlins, cleats and sleeves etc., purlins will need to be set out correctly in the model before applying the joint. The correct offset from the rafter flange should be obtained from the manufacturer's own literature. For consistent cleat positions along a run of purlins, the joint will ignore the inclusion/exclusion of a sleeve when positioning the cleat. Thus, any sleeves will clash with cleats in the model, and it is recommended that they be excluded from clash checks by using the select filter, e.g. enter SLEEVE in the Name field.
    2. It is also recommended that purlins are set out to the rafter centre-line and any gable overhang is entered into the relevant joint parameter.

Selection order example

Select a Cleat Thickness under the Parameters tab

  1. Rafter
  2. Purlin
  3. Purlin
  4. Click middle mouse button

The order to select Tekla Structures model when adding Kingspan Horizontal Cladding Sleeve (120)

See also

Kingspan cold rolled - Important information
Kingspan Horizontal Cladding Sleeve (120) - Parts tab
Kingspan Horizontal Cladding Sleeve (120) - Parameters tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet