Unitechnik export: Validation tab
Unitechnik export: Validation tab
Use the Validation tab to control the Unitechnik export properties.
Option |
Description |
---|---|
Draw scanned geometry |
The exported geometry can be shown with Draw scanned geometry. This property shows the inside lines of the exported reinforcing bars. Select whether you want to check if the geometry of the exported parts is correct. It shows the lines representing the exported rectangle of the basic shape, the exported geometry of parts, cuts, embeds, and reinforcement. Embeds are projected to the plane of the basic shape. The reinforcement lines are positioned inside each reinforcing bar.
|
Draw pallet axis | Select whether to show the coordinate system. The axes are displayed with dotted lines. |
Wall to pallet checking | Select whether the export checks the wall size against the pallet size. If you select the Yes, if exceeded, do not export option, the Pallet width Pallet length , and Max. cast unit thickness options cannot be empty. |
Pallet width | Define the pallet width. With the help of pallet width and length the Wall to pallet checking option can check if a wall element is too big and does not fit to a pallet. If the wall element does not fit to a pallet, the wall element is turned. |
Pallet length | Define the pallet length. |
Max cast unit thickness | Define the maximum cast unit thickness. To avoid collision with the drying chamber, the maximum thickness of a cast unit should be smaller than the maximum opening of the drying chamber. |
Rebar diameter limitation |
Minimum and maximum diameter for the reinforcing bars to be exported. |
Rebar length limitation |
Minimum and maximum length for the reinforcing bars to be exported. |
Rebar length limitation (Longitudinal) |
Minimum and maximum diameter for longitudinal reinforcing bars to be exported. |
Rebar length limitation (Cross) |
Minimum and maximum length for cross reinforcing bars to be exported. |
Export others |
Select whether the reinforcing bars that do not meet the above limitations are exported at all ( No ), as loose reinforcing bars of type 4 or 8, or whether the diameter and length limitations are ignored. |