Kingspan Autoform Detail (3)


Software version: 2017

Last updated October 9, 2018 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2017
Environment: 
Not environment-specific

Kingspan Autoform Detail (3)

The Kingspan Autoform Detail joint only works with Kingspan Multichannel sections and is used to create an autoform at the end of a Multichannel.

Before and after

Tekla Structures model before adding Kingspan Autoform Detail (3) Tekla Structures model after adding Kingspan Autoform Detail (3)Tekla Structures model after adding Kingspan Autoform Detail (3)

Notes

  • Any modification of the selected parts will cause this joint to be updated.
  • If specific values are entered under the Parameters tab, thus overriding the default settings then non standard parts may be created.

Selection order example

  1. Multichannel
  2. Pick a position along the multichannel where the autoform should be created

The order to select Tekla Structures model when adding Kingspan Autoform Detail (3)

See also

Kingspan cold rolled - Important information
Kingspan Autoform Detail (3) - Parameters tab
Kingspan Autoform Detail (3) - Bolts tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet