Ayrshire Non-Continuous Rail (106)


Software version: 2017

Last updated September 28, 2018 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2017
Environment: 
Not environment-specific

Ayrshire Non-Continuous Rail (106)

The Ayrshire Non-Continuous Rail System joint is normally used when the specified column face to cladding distance is less than that possible for the standard purlin/rail joint. The joint can handle flush or recessed sheeting lines. A non-standard cleat, (either angle or tee), is welded to the column, and bolted to the rail using holes along the standard gauge lines.

Before and after

Tekla Structures model before adding Ayrshire Non-Continuous Rail (106) connection Tekla Structures model after adding Ayrshire Non-Continuous Rail (106) connection

Notes

  • Any modification of the selected parts will cause this joint to be updated.
  • If specific values are entered under the Bolts tab, thus overriding the default bolt positions then non standard parts may be created.

Selection order example

  1. Column
  2. Rail

The order to select Tekla Structures model when adding Ayrshire Non-Continuous Rail (106)

See also

Ayrshire cold rolled - Important information
Ayrshire Non-Continuous Rail (106) - Parts tab
Ayrshire Non-Continuous Rail (106) - Parameters tab
Ayrshire Non-Continuous Rail (106) - Bolts tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet