Albion Eaves Brace (64)


Software version: 2017

Last updated September 27, 2018 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2017
Environment: 
Not environment-specific

Albion Eaves Brace (64)

The Albion Eaves Brace macrosaved series of actions that includes instructions for a program

Macros are located in the applications and components catalog. They are recorded or created manually and stored as .cs file in a folder defined with the advanced option XS_MACRO_DIRECTORY.

Macros can, for example, be used for creating drawings or reports.

Macros are sometimes used to run an application.

can be used to define an eaves brace individually between an eaves beam.

Before and after

Tekla Structures model before adding Albion Eaves Brace (64)Tekla Structures model after adding Albion Eaves Brace (64)

Notes

  • It is important to realise that any modification of the parts to which this macro applies is likely to cause incorrect results in the model. This is because the items created by a macro are not redefined when changes are made to the previously selected members. If it is necessary to change any of the members upon which the macro is dependent then first delete all the parts created by the macro, make the required changes and finally re-apply the macro.
  • Most of the data required for this macro is fixed by Albion and stored in a series of data files supplied with Tekla Structures. Where standard data is not applicable, then certain items can be modified through the Parameters tab of the properties panel, but it is also possible to tailor the data files to individual requirements. This would require assistance from Tekla Structures support.
  • All purlin lengths must be parallel.
  • All purlins must have the same offset from the rafter.
  • A double cleat will always be defined to the eaves beam. The purlin may have either a double or single cleat added depending on the information entered in the Parameters tab. The point selected in this macro sets the position of the strut along the member. 

Selection order example

  1. Eaves beam
  2. Purlin
  3. Pick a point or hole (the point must be a Tekla point object, rather than a snap pointpoint to which Tekla Structures snaps

    )

The order to select Tekla Structures model when adding Albion Eaves Brace (64)

See also

Albion cold rolled - Important information
Albion Eaves Brace (64) - Parts tab
Albion Eaves Brace (64) - Parameters tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
Average page rating: 1 (3 votes)
Refresh page after voting to show updated result.