Albion Cold Rolled Cleat (110)


Software version: 2017

Last updated September 26, 2018 by Trimble Solutions UK tekla.support.uk@trimble.com

Software version: 
2017
Environment: 
Not environment-specific

Albion Cold Rolled Cleat (110)

The Albion Cold Rolled Cleat joint connects between various combinations of compatible ‘I’, ‘Z’ and ‘C’ sections. It is possible to specify any angle profile for the cleat, this allows it to be tailored to design requirements.

Before and after

Tekla Structures model before adding Albion Cold Rolled Cleat (110) joint Tekla Structures model after adding Albion Cold Rolled Cleat (110) joint
Tekla Structures model before adding Albion Cold Rolled Cleat (110) jointTekla Structures model after adding Albion Cold Rolled Cleat (110) joint

Notes

  • Any modification of the selected parts will cause this joint to be updated.
  • Secondary members must be perpendicular to the primary member.
  • Connections with two secondaries require them both to have the same orientation. 
  • To obtain the correct Albion cleat, set restraint type to SW Cleat under the Parameters tab of the properties panel.

Selection order example

  1. Continuous member
  2. Non-continuous member
  3. Click middle mouse button

The order to select Tekla Structures model when adding Albion Cold Rolled Cleat (110)

See also

Albion cold rolled - Important information
Albion Cold Rolled Cleat (110) - Parts tab
Albion Cold Rolled Cleat (110) - Parameters tab
Albion Cold Rolled Cleat (110) - Bolts tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet