Albion Non-Continuous Rail (106)

Software version: 2017

Last updated September 26, 2018 by Trimble Solutions UK

Software version: 
Not environment-specific

Albion Non-Continuous Rail (106)

The Albion Non-Continuous Rail System joint is normally used when the specified column face to cladding distance is less than that possible for the standard purlin/rail joint. The joint can handle flush or recessed sheeting lines. A non-standard cleat, (either angle or tee), is welded to the column, and bolted to the rail using holes along the standard gauge lines.

Before and after

Tekla Structures model before adding Albion Non-Continuous Rail (106) connection Tekla Structures model after adding Albion Non-Continuous Rail (106) connection


  • Any modification of the selected parts will cause this joint to be updated.
  • If specific values are entered under the Bolts tab, thus overriding the default bolt positions then non standard parts may be created.

Selection order example

  1. Column
  2. Rail

The order to select Tekla Structures model when adding Albion Non-Continuous Rail (106)

See also

Albion cold rolled - Important information
Albion Non-Continuous Rail (106) - Parts tab
Albion Non-Continuous Rail (106) - Parameters tab
Albion Non-Continuous Rail (106) - Bolts tab

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.
Content rating: 
No votes yet