Export Unitechnik (79) contains the following improvements:
Reinforcement tab: You can now export spacer start position and spacer pitch information with the new settings Spacer start position and Spacer pitch.
Reinf. data specification tab: The new option Welded leg designation can be used for designating the welded leg in bent meshreinforcement that represents a mesh of steel bars in two perpendicular directions
In Tekla Structures, the reinforcement mesh bars in one direction are called main bars and reinforcement mesh bars perpendicular to them are called crossing bars.
bars. When you select Yes, information about welded leg designation is exported.
- Reinf. data specification tab: In Pull force, specify the attribute from which the strandreinforcement that represents a group of wires spun together
pull force is to be inquired. In Unitechnik version 6.0, you can set the Unitechnik reinforcement type to 9 in the reinforcing barreinforcement that represents a steel bar used to reinforce a concrete structure
The steel bars are usually ribbed and they are used to increase the tensile strength of concrete.
user-defined objects on the Unitechnik page, and then it will be exported as strand reinforcement with its value in KN (taken from UDAobject property created by the user in order to widen the range of predefined object properties
User-defined attributes are used when the predefined object properties are not sufficient but more properties are needed. For example, comment, locked, and erection status are user-defined attributes.
HEADER block data specification tab: It is now possible to specify building site and building owner name, address, post code and city/town.
When you used rotation in export, the line attribute override did not take rotation in to account. This has now been fixed.
- It is now possible to export reinforcement bars as mount parts.
You can now specify the transport pileslender column or pole that is put into the ground to carry loads or to provide support
Pile may be made of precast or cast-in-place concrete, or steel.
level number in part user-defined attributes dialog box on the Unitechnik tab. If there are elements in the stack which need to be layered on the same level, then the pile level is used.