Hello!

Did you know that logged in users can see a lot more content?

123544, 131774, 132217, 131686, 131997, 132426

Fixed defect

Last updated November 10, 2017 by Tekla User Assistance tekla.documentation@trimble.com

123544, 131774, 132217, 131686, 131997, 132426

Export Unitechnik (79) has been improved in the following way:

  • It is now possible to export reinforcement bars as mount parts.

  • You can now specify the transport pileslender column or pole that is put into the ground to carry loads or to provide support

    Pile may be made of precast or cast-in-place concrete, or steel.

    level number in the part user-defined attributes dialog box on the Unitechnik tab. If there are elements in the stack which need to be layered on the same level, then the pile level is used.

  • When you used rotation in export, the line attribute override did not take rotation in to account. This has now been fixed.

  • Reinf. data specification tab: In Pull force, specify the attribute from which the strandreinforcement that represents a group of wires spun together

    pull force is to be inquired. In Unitechnik version 6.0, you can set the Unitechnik reinforcement type to 9 in the reinforcing barreinforcement that represents a steel bar used to reinforce a concrete structure

    The steel bars are usually ribbed and they are used to increase the tensile strength of concrete.

    user-defined objects on the Unitechnik page, and then it will be exported as strand reinforcement with its value in KN (taken from UDAobject property created by the user in order to widen the range of predefined object properties

    User-defined attributes are used when the predefined object properties are not sufficient but more properties are needed. For example, comment, locked, and erection status are user-defined attributes.

    ).

  • Reinf. data specification tab: The new option Welded leg designation can be used for designating the welded leg in bent meshreinforcement that represents a mesh of steel bars in two perpendicular directions

    In Tekla Structures, the reinforcement mesh bars in one direction are called main bars and reinforcement mesh bars perpendicular to them are called crossing bars.

    bars. When you select Yes, information about welded leg designation is exported.

  • Reinforcement tab: You can now export spacer start position and spacer pitch information. The new settings Spacer start position and Spacer pitch are located on the.

Development area: 
Import, export, interoperability

Quick feedback

The feedback you give here is not visible to other users. We use your comments to improve our content.
We use this to prevent automated spam submissions.